Welding procedure specification

Tag: job qc inspector

Welding procedure specification
17 September 2021


blogs

Recommendations for Welding

 We would see about Recommendations for Welding of Structural Steel as per AWS D1.1 , 2020 revision Groove Weld: (Clause 4.4.1) Weld Length : shall be the width of the parts joined , perpendicular to the direction of compressive or tensile stress, Weld Size:  Thickness of thinner…
0 By AQC-Inspections 
Welding standards
21 August 2021


blogs

Weld Position- Fillet Welds

 Fillet Weld Positions The advantage of the fillet-welded joint is that it’s unnecessary to prepare the edges of the plates or sheets for welding. Double fillet-welded joints are an improvement over single-fillet joints because they can withstand loads from more than one direction. Three of the…
0 By AQC-Inspections 
welding symbols
14 August 2021


blogs

STANDARDS FOR WELDING POSITIONS

 Standards for Welding Positions: It is very important for the Weld Inspector to know the position, or location of a joint relative to the horizon, because it may determine what welding process, methods, and techniques can be used. Welding is usually easiest when the welder can…
0 By AQC-Inspections 
Welding types
4 June 2021


blogs

Types of Welding

 Types of Welding Welding process involves joining of two metals and sometimes non-metals such as plastic There are many different types of weld, as below: Arc welding Atomic Hydrogen Welding ( AHW) Bare Metal Arc Welding (BMAW) Carbon Arc Welding (CAW) CAW-G—– Gas CAW-S—-Shielded CAW-T—–Twin Electro Gas Welding (EGW) …
0 By AQC-Inspections