29 July 2022


blogs

RT acceptance Criteria

RT ACCEPTANCE CRITERIA AS PER ASME SEC VII DIV-1 for PRESSURE VESSEL RT ACCEPTANCE CRITERIA AS PER ASME SEC IX for TEST Pieces WQC/PQR RADIOGRAPHY TESTING ACCEPTANCE CRITERIA AS PER…
jobs in Oil and gas
14 July 2022


blogs

Oil and gas jobs

Below are the list of Oil Gas Companies  which might guide the Job seekers to apply and get oil and Gas Jobs opportunities / foreign jobs . People with various qualifications as Engineers of Process Engineering, Designing, Non Destructive Testing NDT, Welding Inspection, Instrumentation,  HVAC,…
welding procedure
8 July 2022


blogs

WELDING INSPECTION DUTIES

Welding Inspection duties General Conditions:    Understand shop drawings, erection drawings, referenced codes and standards. Review the manufacturer’s Material Test Report (MTR). Verify all materials properties and that all materials are readily identifiable and traceable to an MTR.    Conduct a complete visual examination…
1 July 2022


blogs

Steel Making Process

Steel Making Process Steel is an alloy of iron usually containing less than 1.5% carbon. Steel can be cast into bars, strips, sheets, nails, spikes, wire, rods or pipes as needed by the intended user. Steel making process  at an integrated steel plant involves three basic…
visual inspection on welding
23 June 2022


blogs

Training Institute for Welding and NDT

Equipment’s required for Welding Institute set up. Welding is a process of joining metals or nonmetals such as plastic. There are different types of welding, and few of them are as below. SMAW- Shielded Metal Arc Welding (commonly…
17 June 2022


blogs

Material Testing

Material testing Mechanical testing  have been designed to test several weld properties.Few other material testing techniques are Charpy V-Notch Toughness: Notch toughness is the capacity that a material possesses to absorb energy in the presence of a flaw, such as a notch or crack. The material will…
Mechanical testing
10 June 2022


blogs

Mechanical Tests – Tensile Test – Impact test

Mechanical tests. Mechanical tests (exclusive of hardness) have been designed to test several weld properties. 1.    Tensile Test:    Tensile tests are conducted on specimens machined from a test weld and are used to measure the strength of the weld joint. Specimens are usually taken perpendicular to…
welding procedure
27 May 2022


blogs

Welding Safety

Welding Safety with Gas Cylinders On an oxyacetylene system there will be three types of valves, the cylinder valve, the regulator valve, and the torch valve. There will always be a set of three valves for each system, since  the gas in the cylinders is…
Welding procedure specification
18 May 2022


blogs

Safety and Precautions during welding

As in any welding process, safety precautions are very important. All information relating to the safe operation of the welding equipment and process must be fully understood before beginning work. A careless welder who does not observe some simple rules can cause a dangerous situation…
Standards on piping inspection
7 May 2022


blogs

Pipe Line Isometric Drawings and P & ID Drawings

Pipe Isometrics : Are drawings which shows details of Process pipe lines in a single line presentation , with details of pipes, pipe connections ( valves, flanges, nipples, reducers, end cap, elbow, etc), along with the dimensions and direction of  pipe line. Example of a…