welder qualification
8 August 2022


blogs

Types of Weld Joints

Here we are going to see about two types of weld Joints Groove Welds Fillet Welds Dimensions 1.1.  Groove Welds: In the following figures, the perspective drawings of types of weld joints are shown at the left, looking at each joint from the arrow side. The…
welding procedure
8 July 2022


blogs

WELDING INSPECTION DUTIES

Welding Inspection duties General Conditions:    Understand shop drawings, erection drawings, referenced codes and standards. Review the manufacturer’s Material Test Report (MTR). Verify all materials properties and that all materials are readily identifiable and traceable to an MTR.    Conduct a complete visual examination…
visual inspection on welding
23 June 2022


blogs

Training Institute for Welding and NDT

Equipment’s required for Welding Institute set up. Welding is a process of joining metals or nonmetals such as plastic. There are different types of welding, and few of them are as below. SMAW- Shielded Metal Arc Welding (commonly…
Welding procedure specification
18 May 2022


blogs

Safety and Precautions during welding

As in any welding process, safety precautions are very important. All information relating to the safe operation of the welding equipment and process must be fully understood before beginning work. A careless welder who does not observe some simple rules can cause a dangerous situation…
Welder Qualification
3 May 2022


blogs

Weld crack

Weld crack   1.1. Cracking: If a weld crack is found, it must be removed and magnetic-particle inspection performed to ensure every point has been removed before re-welding. Weld Crack can occur on top of a weld…
welding institute
23 April 2022


blogs

Dissimilar metal in TIG Welding process

Why use this TIG welding process: TIG Tungsten Inert Gas otherwise called as GTAW- Gas Tungsten Arc Welding , Involves melting the metal using the arc created by tungsten electrode, The welding can be done with or without filler metal, Argon Gas is used as shielding around…
welding symbols
20 April 2022


blogs

WELDING PROCEDURE FOR JOISTS

WELDING FOR JOISTS AND FINISHING OF MACHINING RAILS Unless otherwise authorized by the engineer, any welding to the top flange of steel members for supporting floor form joists and finishing machine rails will not be permitted. Welding of hangers and supports to shear studs will…
31 March 2022


blogs

Weld Test Coupon Preparation

Bend Test Coupon Preparation First the centerline on the plate shall be marked. Then another line 1.0 inch above the center line  and another line 1 inch below the center line. This is the section that can be used as an alternate coupon in the event…
Welding procedure
18 March 2022


blogs

WELDING TEST COUPON PROCEDURES

Welding Procedures Follow a clear example of  test coupons welding procedures for a 3G welding certification. In this 3G  welding procedure the notes were taken from the same section of the AWS code that are used for the 3/8 inch limited thickness test procedure.
Welding standards
11 March 2022


blogs

Weld defects

Failure investigation often uncovers facts that lead to changes in design, manufacturing, or operating practice, which will eliminate similar failures in the future. Failures of insignificant parts can also lead to advances in knowledge and should be done objectively, as with a large structure. The…