blogs
blogs
blogs
WELDING PROCEDURE FOR JOISTS
WELDING FOR JOISTS AND FINISHING OF MACHINING RAILS Unless otherwise authorized by the engineer, any welding to the top flange of steel members for supporting floor form joists and finishing machine rails will not be permitted. Welding of hangers and supports to shear studs will…
blogs
NDT Methods Selection
NDT Method Selection: The NDT (nondestructive testing) methods are: Visual Inspection – VT Liquid Penetrant Testing – LT Magnetic Particle Testing – MT Radiographic Testing – RT Ultrasonic Testing – UT Eddy Current Testing – ET (not used in field inspection) Acoustic Emission Testing –…
blogs
Weld Test Coupon Preparation
Bend Test Coupon Preparation First the centerline on the plate shall be marked. Then another line 1.0 inch above the center line and another line 1 inch below the center line. This is the section that can be used as an alternate coupon in the event…
blogs
Non Destructive Testing- Course and NDT course Fee
Non Destructive Testing has plenty of scope for people interested in Mechanical Industry and also construction sector. This Quality Control Related subjects is thought in almost all major cities all over the world, and the NDT certificates offered by institutes are valuable across the globe. The…
blogs
WELDING TEST COUPON PROCEDURES
Welding Procedures Follow a clear example of test coupons welding procedures for a 3G welding certification. In this 3G welding procedure the notes were taken from the same section of the AWS code that are used for the 3/8 inch limited thickness test procedure.
blogs
Weld defects
Failure investigation often uncovers facts that lead to changes in design, manufacturing, or operating practice, which will eliminate similar failures in the future. Failures of insignificant parts can also lead to advances in knowledge and should be done objectively, as with a large structure. The…
blogs
Welding Inspector certification
Levels of Certification AWS 1:2003 There are three levels of qualifications for welding inspector personnel. These levels are: AWI – Associate Welding Inspector; WI – Welding Inspector; SWI – Senior Welding Inspector. 1.1) Associate Welding…
blogs
Adhesion Test on Paints by Tape Test
Painting Inspection, Adhesion Test, QC Training, QC Course X Cut Test (This Document) Cross Cut Tape Test Method A – X Cut Tape Test An X-Cut is made on the Dry Paint until the bare substrate , a…
blogs